Programmable Constant Temperature and Humidity Test Chamber

Product Introduction
The constant temperature and humidity test chamber, also known as the high and low temperature alternating heat and humidity test machine, is an indispensable test equipment for electrician, aviation, automobile, home appliance, paint, scientific research, etc., used to test and determine electrical, electronic and other products and materials. Dry, drought-tolerant, cold-resistant, moisture-resistant parameters and performance after test temperature changes.

Product Features
Imported high-precision microcomputer color touch screen temperature and humidity controller, switch between Chinese and English,
◆Test hole (left side of the machine) 50mm, can be used for external test power cable or signal cable
◆ Original European and American imported fully enclosed low noise high and low temperature compressor
◆ Double-layer high temperature resistant high-strength sealing strip is used between the door and the box to ensure sealing
◆The inner and outer boxes are made of imported (SUS#304) stainless steel.
◆The observation window adopts multi-layer hollow tempered glass and inner glued sheet type conductive film (the test process can be clearly observed)
◆Safety protection device, when any failure occurs, the fault status is immediately displayed on the screen and the power is cut off to ensure the safety of the machine, the tested product and the use.

Main Technical Indicators

The above indicators are measured at ambient temperature ≤ 25 ° C, under normal pressure, no load, no load conditions, within 1/6 of the inner wall of the tank;

Meet relevant standards and test methods
GB/T2423.22-87Nb GJB1032-90 MIL-STD-2164/(E/C)
GB/T2423.4-93 GB/T2423.34-86 GJB150.9-86